Copyright ©2009, Seymour Products LLC,
www.seymourav.com
, All rights reserved.
Gen4 Standard RF Motor Limits Setting (RF motors with LED dongle)
Your RF remote has a couple programming
functions built in, so unless you’re intending on
tweaking the configuration of the screen, please
do NOT continuously hold down button combos.
If you press and hold both the up and
down buttons down for a few seconds, the
motor will change direction. If you ever
find that up is down and down is up and
you’re sober, then you’ll want to put that
back the way it’s supposed to be. The
motor confirms that it understood your
command with a little bump and flashing
of the LED.
If you are intending to adjust the lower
limits, retract the screen all the way up
first. If you press and hold both the stop and down buttons for a few seconds, you’ve entered
limits programming. Depending on if this was accidental or on purpose, here is what’s going on
while the LED slowly blinks.
o
Upper Limits
When it first starts blinking, it is in the
upper limits setting mode. Is the screen fully retracted
up into the case when you entered this mode?
Yes: Then you won’t need to fix the upper
limits. We very carefully program that here.
Press Stop.
This will exit upper limits
mode and retain the upper position we
programmed. The blinking will change
for a couple blinkings to confirm. You
can proceed to the lower limits part
below.
No: Crap. You’ll need to fix the upper limits setting.
Press Down.
The motor is first in a continuous travel setting. Down is
the safer direction.
Press Stop.
Now you’ve entered the precise or small-bump setting for
the motor. The motor will now only travel following your up/down button
commands.
Bump up/down.
Long presses will travel the motor longer, and little
quick presses will bump the motor. The goal for the upper limits setting is
to get it up into the case as much as possible but making sure that both
ends of the weight bar can still wobble a bit inside, indicating that they’re
not jammed inside. One end may be higher than the other, depending on
how the cables coil up, so target the higher end and carefully bump it into
a hidden, but free hanging position.
Press Stop.
This will exit upper limits mode you just programmed. The
blinking will change for a couple blinks to confirm. You can proceed to
the lower limits part below.
o
Lower Limits
Next, always following the upper limits mode, is the lower limits setting.
Since you just exited the upper limits, I now know your screen is in the upper position
and what you need to do next
Press Down.
The motor is first in a continuous travel setting, so carefully watch
it drop until you’re a few inches away from your targeted setting. Watch the
tension cables to make sure you don’t go past their limits. If you do, you’ll start
winding the cables while dropping the screen and the bar will start to fold up the
