14
Service Settings
The Service Settings menu offers options to determine fundamental
settings of your Séura Mirror Display based on personal preferences.
Adjustment options include:
OSD (cont.)
BOOT POWER OPTION
The
Boot Power Option
setting determines how the Séura Mirror Display boots after a power interruption.
Your options:
Power on, Standby, Last.
Power on:
Mirror Display always starts with power on
Standby:
Mirror Display always starts in standby
Last:
Mirror Display will start to the state it had before power failure
OSD ACCESS
With the OSD Access setting you can deactivate the OSD menu. This will deny users access to the OSD.
If OSD Access has been set to Off access can only be reestablished as follows:
1. Press
2. When the window with the message “Not Available” appears, enter the 4-digit password.
The default password is: 1234.
START LOGO
With the
Start Logo
setting you can (de-)activate the Séura start-up logo for the Séura Mirror Display.
IR ADDRESS CODE
Within the
IR Address Code
menu you can determine an individual remote address code according to your preferences. Available parameter is
from
0
to
61
. The preset
IR Address Code
is
0
.
NOTE: Please bear in mind to program your remote control according to the set code.
INPUT SCAN
With the
Input Scan
setting turned to
On
you can activate the automatic scan of the input ports for input sources. If there is no signal at the
currently selected port the Mirror Display searches for a signal on the other ports in the following order: HDMI 1, 2, 3, Component. If a signal is
found then the Mirror Display will select this port. See also
Signal Loss Timer
below.
SIGNAL LOSS TIMER
With the
Signal Loss Timer
setting you can set the time the
Input Scan
will be performed. If
Signal Loss Timer
is set off the search will continue
indefinitely or until a signal is found. If
Signal Loss Timer
is set to
5, 10, 30, 60, 120
seconds the Mirror Display switches to standby mode if no
alternative signal was found within the chosen time.
VOLUME LIMIT
With the
Volume Limit
setting you can determine a maximum volume according to your preferences. This setting is useful to prevent a user from
increasing the volume above a certain level e.g. in a hotel not to disturb neighboring rooms.
INPUT PORTS
Within the
Service Settings
menu you also have the possibility to (de-)activate the input ports. If an input port is set
Off
it will not be accessible in
the
Input Source Selection
.
Available input ports:
HDMI 1, HDMI 2, HDMI 3, Component (YPbPr), USB
.
NOTE: Please notice that if USB is set Off this does not affect the Software Update function. The Software Update function is always
possible even if the USB input port is set Off.
Boot Power Option
OSD Access
Start Logo
IR Address Code
Input Scan
Signal Loss Timer
Volume Limit
HDMI CEC
RS-232 Access
Baud Rate
Change Password
Additionally you can (de-) activate the Input Source ports
HDMI 1, HDMI 2, HDMI
3., Input Component
and
USB
.
NOTE: To access the Service Settings menu please enter the 4-digit password.
The default password is: 1 2 3 4.
2010 Remote Redesign
Final
w a t e r p r o o f
last
ok
enter
channel
volume
cc
guide
mute
sleep
zoom
input
display
menu
exit
