ST-EG100-E Installation and User Guide Configuration
Resulting Email
Email Header:
From: [email protected]
To:
[email protected]; [email protected]
Subject: [ST-EG100-E] Custom Subject Test for Email 1
Message Body:
A test email for multiple recipients and custom subject, with embedded reports for ST-
EG100-E Firmware.
Zone Status Report
Zone
State
Status
1. Front House Door
Short
Normal
2. Utility Room
Door
Open
Violated
4. Garage Rear Door
Short
Normal
Zone Alarm Report
Zone
Alarm Type
2. Utility Room
Door
Burglar Entry/Exit 1
Area Arming Status Report
Area
Status
State
Alarm
1. House
Armed
Away
Armed
Burglar
2. Barn
Disarmed
Not Ready
No Alarm
3.4.3. Dynamic DNS Setup
To access an ST-EG100-E on the Internet, you need to know its Public IP Address. The Internet
service provider may change that IP address from time to time. Because IP addresses change and
are difficult to remember, you can sign up for a free or low-cost service known as Dynamic
DNS. This service allows you to select a semi-custom URL and register it to your IP address.
When your IP address changes, the DDNS service will update your URL to point to the new
address. The ST-EG100-E can be set up to automatically update the DDNS provider when your
IP address changes.
Before setting up the ST-EG100-E to do this, you must register for a DDNS account. There are
several available that will work with the ST-EG100-E. The ST-EG100-E has been tested and
proven to work with the following three DDNS providers (although there may be more):
•
DynDNS www.dyndns.com
•
No-IP www.no-ip.com
SETECH Security & Automation
Revision
1
96-300001
Page 20 of 44