Sesamo SwinGo, Инструкция по установке, Страница: 9 / 19

Installation Instruction
9
Use of adapter plate (optional)
If one or more fastening points of the Swingo plate are unusable for firmly anchoring the automatism to the fixed part, use
the optional adapter plate.
Gearmotor Axis
Articulated push arm
Wing Attachment
102
25
25
25
5
15
WARNING : For a correct positio-
ning of the Swingo with the optional
adapter plate, use the dimensions
shown in the previous figures.
OPENING DIRECTION
Adapter plate
(optional)
Installation of the guide and rigid pull arm
Fig. 11
A
B
C
D
E
F
G
Fig. 9
Insert the bracket of the arm (Fig.10 Part A) in the appropriate seat
on the gearmotor and fix it using the two countersunk-head screws
provided (Fig.10 Part B).
Fig. 10
Access the fastening compartment of the guide (Fig.11 Part A) by
removing the cover (Fig.11 Part B). Make at least 4 holes correspon-
ding to the "V" impression on the guide profile. Use the holes to fix
the guide to the frame using the appropriate screws (Fig.11 Part C).
Insert the cylindrical slide (Fig.11 Part D), complete with the relative
spindle, inside the guide and distribute a uniform layer of grease
over the sliding zone.
Then, after finishing the installation of the rigid arm
(Fig.11 Part E), screw the threaded shaft, inserted in
the cylindrical slide, into the hole prepared on the end
of the rigid arm. Close the guide with the caps (Fig.11
Part F) and the screws provided (Fig.11 Part G).
A
B