Sesamo SwinGo, Инструкция по установке, Страница: 10 / 19

10
Installation Instruction
Assembly of the articulated push arm
Insert the 3 appropriate plastic bushings (E) into the articulated arm brackets (Fig.13 Parts A, B and C) and the plastic bus-
hing (F) into the wing attachment bracket (D).
Insert the pin with the single groove (G) into the brackets (A) and (B) assembled previously, place a 1mm-thick shim (H) in
between and a 0.5mm thick shim (M) in betweenand block with a seeger (I).
Insert the pin with two grooves (L) into the brackets (C) and (D) assembled previously, place a 1mm-thick shim (H) and a
0.5mm thick shim (M) in between and block with a seeger (N).
Block the preassembled parts using the three screws provided (O).
WARNING : The articulated arm is NOT symmetric. Depending on the opening direction (right-hand or left-hand), posi-
tion the brackets of the arm and the bushings as indicated in the following figures.
Insert the bracket of the arm (Fig.13 part A) in the appropriate seat on
the gearmotor and fix it using the two countersunk-head screws provi-
ded .
Carefully check that the upper part of the articulated arm rotates easily
under the frame of the wing (Fig. 7 , 8 and 9)
Drill the frame at the positions indicated in Fig.7 and fix the wing attach-
ment of the articulated arm to the frame using the appropriate screws.
Close the wing, loosen the fastening screws on the adjustment slots
and then, lengthening the extendable part of the arm, reproduce the
exact geometry shown in Fig.12.
Fix the adjustment by firmly tightening the clamp screws on the exten-
dable part of the arm so as to use the prepared holes separated by the
largest distance.
WARNING : Carefully check that the seegers are inserted perfectly in the respective grooves.
Fig. 12
Wings
Right Opening
Wings
Left Opening
WARNING : Check that when the door is completely open, the
angle formed by the articulated arm does not exceed 140°. Fig. 14
max 140°
Fig. 14
Fig. 13
A
C
D
E
F
G
E
E
H
I
H
M
N
M
O
L
B