Sesamo SwinGo, Инструкция по установке, Страница: 11 / 19

Installation Instruction
11
Power connections
WARNING : Before performing the following operations
make sure the mains are disconnected. Before powering
the equipment, perform the controls foreseen in paragraph
“
Start up ”.
Place the power cord in the automatism paying careful
attention not to damage the cord against any metallic edges.
Connect mains and grounding wires on the terminal board
(Fig. 16)
WARNING : Never invert the power wire with the groun-
ding wire.
Power must be isolatable from the general panel with a bi-
polar switch with minimum contact opening equal to 3 mm.
(not supplied).
Fig. 16
Adjustment of the Stop
220V AC
Final operations
Before starting the automatism, check and perform the following:
• Accurately remove and dust or shavings
• Ensure the proper fixing of the automatism on the wall
• Check correct tightening
• Check that the wires are fixed and that no wire pass near the carriage sliding area.
• Check that the arm is solidly fixed to the wing and that it is equipped with the appropriate stop to limit the max opening
angle to 100°.
Electrical connections
WARNING : All board or peripheral connections on the terminal board must be performed with the power disconnec-
ted to prevent irreparable damage to the electronic equipment.
WARNING : Any repairs or replacements must be performed by professionally qualified personnel and original spare
parts must be used in repairs.
Battery connections
Connect the battery wiring to the proper clamp on the electronic
board
Open the wing to the desired opening limit, then position the rubberized stop on the floor and tighten the screw on the
stop.
WARNING : The max. allowed opening angle is 100°.
Fig. 15