Servonaut RX9, Технические характеристики, Страница: 26 / 32

23
If you use a plug-in module the RX9
detects the battery voltage and trans-
mits an alarm to your radio. To do that
your RX9 has to know the battery type.
With 2S, 3S, 4S LiPo and NiMH (6 and
10 cells) the RX9 gets it automatically.
If you use a different type or the auto-
matic does’t work you can select the
battery type by hand using a Servonaut
ProgCARD setup tool. (See chapter
Setup with ProgCARD or Radio
HS12/HS16 on page 26.)
Partner Mode with two Receivers
First bind two receivers to one radio
(see chapter
Binding Receiver and Ra-
dio ). One receiver is the master, the
other the slave. After binding remove
the jumper on
Slave only on the slave
receiver.
If you use a Zwo4 plug-in you have
two options:
· If you bind master and slave to the
same position of the level switch,
both receiver work at the same time.
·
If you bind master and slave to dif-
ferent positions of the level switch
you can use the switch to alternate
between the receiver. This way you
can use the servo channels twice.
You can’t use a slave without a master
receiver. Master and slave behave dif-
ferent when you switch to another mod-
el: The master receiver stops sending
signals to the servos. The slave receiver
will continue sending the last signals it
received. You can’t use an older Servo-
naut E9 or E18 as a slave receiver.
Please note: The battery monitoring
only works with the master receiver.