Servomex NanoTrace DF-760E, Инструкция по эксплуатации

Страница: 116 / 182

112 DF-760E User Interface
8.000 VDC. This process can be repeated as often as needed. When done, the
NEXT
key is
used to move to the
Done
field and the
Enter
key is hit to leave the screen. The condition
of the analog output before the test is restored when the test is concluded. See the section
on analog outputs found on page 42 for additional information.
Figure 129: Test Moisture Analog Output
7.7.8.2 Test Oxygen Analog Output
The Test Output screen, as shown in Figure 130 is used to calibrate the oxygen analog
recorder output. When the Test Output screen is selected, the
NEXT
key is used to move
to the percentage field where the arrow keys ( and ) are used to choose the
appropriate setting. The
NEXT
key is then used to move to the
Apply
field where the
Enter
key is hit to set the analog output to the selected value. The analog output response
should match the value that was entered. For example, if 80 percent is entered for the
percent full scale level, and the analog output is set for 0 to 10 VDC, the analog output is
8.000 VDC. This process can be repeated as often as needed. When done, the
NEXT
key is
used to move to the
Done
field and the
Enter
key is hit to leave the screen. The condition
of the analog output before the test is restored when the test is concluded. See the section
on analog outputs found on page 42 for additional information.
Figure 130: Test Oxygen Analog Output