Quick Start Guide
SERVO
PRO CHROMA/NANOCHROME/ULTRA Gas Analyser
31
04400003A_0
3
INSTALLATION AND SETUP
CAUTION
Only apply power to the analyser in accordance with the Start-up
Procedure (Section 4.3). Incorrect start-up may cause damage to the
analyser.
3.1 Electrical installation
3.1.1 Electrical safety
Refer to Operator manual for Electrical Safety
3.1.2 Master chassis electrical connections
Figure 16 shows how to connect an analyser supplied with only a master chassis.
The master chassis must be connected to a power source using a properly rated
cable (see section
Error! Reference source not found.
).
If an auxiliary oven is supplied, connect the cable coming out of the auxiliary
oven to
the chassis connector named “Auxiliary Oven” (see section
1.2.1). The
cable carries the power supply and the temperature measurement.
Figure 16 : Master chassis electrical connections
WARNING
The units shall only be connected using the cables supplied by
Servomex.
