Serpent SRX2 GEN3 CARPET, Инструкция по эксплуатации

Страница: 19 / 44

19
REaR aSSEmbly
2x10
10x15x4
5x13x4
4
5
8
1
M2x5
STEp 28
M2x5
2
2x10
7
2x10
10x15x4
5x13x4
Mount pin in middle hole by default
REAR WHEEL-AXLE PIN FOR DRIVESHAFT POSITION
The axle has 3 pivoting
choices. The shallowest hole
will provide more chassis
roll / less roll stiffness. The
deepest hole will reduce
chassis roll / increase roll
stiffness. The center hole is
recommended as its neutral.
3
6
REAR AXLE HEIGHT AND OFFSET INSERTS
1) The axle height adjustment will give you the ability to adjust the roll
center for various traction conditions. Typically in lower grip, you will
run 0,+0.5,1 or 1.5mm / lower roll centers. In higher grip conditions
you will want to use +2,2.5,3mm / higher roll centers.
2) The width offset will give you more versatility to adjust the track
width, axle location and hex width. Especially useful when using
Longer rear arm.
Wide Offset Narrow
0.5mm
1mm
1.5mm
2mm
2.5mm
3mm
0mm
L R L R
0.5mm
1mm
1.5mm
2mm
2.5mm
3mm
0mm
baG 8