Serpent 400007, Инструкция по эксплуатации и справочник

Страница: 6 / 28

Remove the battery cover
and put in 4 AA size
batteries.
Charge connector
Steering wheel
Throttle trim
Throttle trigger
Steering trim
LCD display
+/- button
Sel/Ch button
ST D/R button
Th D/R button
Power switch
Grip handle
Battery box
Switch
Connectors
1: Steering servo CH1
2: Throttle servo CH2
3: CH3 servo CH3
4: CH4 servo CH4
B/C: Power connector
Receiver functions
Fail
Safe
Set
Transmitter system
The car comes complete with the Digital Proportional Dragon-RC DTS-1 2.4 gHz transmitter (#
210000)
.
The Dragon DTS-1 transmitter is an advanced 2.4 gHz radio-system with LCD screen, and clear settings which
are easy to tune through the menu and screen.
The transmitter is pre-tested, checked for proper functioning, and pre-set with default, to operate the car.
In case you want to change any setting then follow the manual as per below.
Read very carefully before making changes. Its always possible to restore default settings if needed.
LCD Transmitter operation
The transmitter is powered by 4 cells AA 1.5V. As soon as you turn on the power switch, it starts to run. ST controls the
steering. TH controls throttle. After turning on the transmitter, the LCD display shows Battery Voltage and the model
number which you have selected last time. SEL +/- are used for setting model parameters and operation steps.
1. Pres +/- to operate model number, value range from 01-15,model name and number will be shown on the display.
2. Press SET to set the parameters, such as REV, EPA, ABS, EXP, MODEL NAME.
A. Set REV, press CH key then enter ST/TH/3C and press +/- then enter ON/OFF.
B. Set EPA: press CH then enter ST/TH, steering control L/R, throttle control F/B, LFU/RBU in LCD
select choice, +/- set the number value, range 0-120%.
C. Set ABS: press CH then enter ST/TH, press +/- then enter ON/OFF.
D. Set EXP: press CH then enter ST/FORWARD/BACK, press +/- to set value range -100% -- +100%
E. Set MODEL NAME: press CH to move the setting characters position, press +/- to set value range 0-9, A-Z.
3. Press SEL key to exit setting state, parameters are auto saved.
4. Set TRIM-ST: press TRIM-ST+, TRIM-ST- to change TRIM-ST value, range 0-100%R, 0-100%L.
5. Set D/R-ST: press D/R-ST+, D/R-ST- to change D/R-ST value, range 0-100%L, 0-100%R.
6. Set D/R-ST: press D/R-TH- to change D/R-TH value range 0-100%F, 0-100%B.
7. Press SET key to exit the setting of TRIM, D/R, without operation after one minute it will save.
6
Th rate adjuster
ABS = anti lock F/S = fail safe
breaking system REV = reverse
CH = channel ST = steering
D/R = dual rate TH = throttle
EPA = end point adjustment more info: check
EXP = exponential www.easyrc.com