SP25 VDE OM 2.0-1 (2006)
7
•
Adequate ventilation must be provided as specified in the section of this manual
entitled “Where to put the SeriPrinter”.
CAUTION
•
Protect the equipment from direct sunlight, dampness or wet weather, such as rain,
snow, and so on.
•
While printing, do not turn off any portion of the system. To do so will cause
damage to integral components and damage the belts.
•
While printing, do not open the cover.
•
While printing, do not unplug the power cord.
•
While printing, do not move the machine.
•
Keep all liquids off the machine.
•
Do not allow paper clips, staples, or other small objects to fall inside the machine
•
Be careful not to cut yourself on any sharp edges when you reach inside the machine
to remove miss fed sheets of paper.
•
Do not spill liquid on the machine.
•
Do not sit on the machine.
•
Do not place the machine up against a wall. Ensure that there is no less than 50cm
between the machine and the wall.
•
Unplug the power cord from the wall outlet before you move the equipment. While
moving the equipment, you should take care that the power cord will not be damaged
under the equipment.
•
If you clean rubber parts with benzine, or other volatile solvent, wipe them with a
dry cloth afterwards.
•
Always print with UV filter cover in place.
•
Do not open any panels marked - HIGH VOLTAGE
•
Always turn the power to the machine off when you have finished printing for the
day.
•
When the machine will not be used for long periods, disconnect the power plug
from the wall outlet, always pull the plug (not the cable).
•
If the machine must be transported by vehicle, please contact your service
representative.
•
For environmental reasons, do not dispose of the equipment or expended supply
waste at household waste collection points. Disposal can take place at an authorized
dealer or at appropriate collection sites.