Serious RED 52K650Z, Руководство оператора

Страница: 9 / 20

ENCORE
8
To test drive operations:
„
Check air pressure in tires. Equal tire
pressure is critical for proper drive
opeation.
„
Check linkage for excessive play.
•
Raise rear of Rider until rear wheels
are off the ground. Safely block the
frame in this position.
•
Put control levers in neutral lock
position (control levers swung
outward).
•
Start engine.
Wheels should not rotate. If one or both rear
wheels are turning, perform procedures under
“Neutral Adjustments” for side(s) that wheel
turns (fig. 3).
DECK HEIGHT ADJUSTMENT for
42B350Z ; 42K450Z ; 48B450Z ;
48K550Z ; 52B550Z ; 52K650Z.
The cutting height can be adjusted from 2 to
5 inches in approximately 1/4 inch incre-
ments. The height may be selected by simply
moving the deck height adjustment lever to
desired cutting height.
CAUTION:
TURN OFF ENGINE BEFORE MAKING ANY
ADJUSTMENTS.
2 to 2 1/2 inches
each notch
approx. = 1/4"
4 to 4 1/2 inches
RAISE
LOWER
DECK HEIGHT ADJUSTMENT LEVER
DECK HEIGHT ADJUSTMENT for
42K17Z ; 48K19Z ; 52K21Z.
Mower heights can be adjusted by pushing
the foot pedal and by depressing the height of
cut pin and removing it. Select cutting height
and set pin accordingly.
BLOCK OF WOOD
FIG. 5
BLADES
When removing blades, block front end up or
run front wheels onto ramps. Stop engine
,
remove key from the ignition switch , and
apply park brake. To remove, simply hold
blade bolt on bottom of the cutter housing
(See Fig. 5) and turn nut counter-clockwise.
Reverse procedure to reinstall. Blade bolts
should be torqued to 110 - 120 ft.lbs.
Note: Deck spring washer should always be
cup side up or cup side to blade to insure
proper torque on the blades.