Serious RED 52K650Z, Руководство оператора

Страница: 4 / 20

ENCORE
3
4. Take the 4 – 5/16 X 3/4 HHCS and
4 – Lock Washers and fasten seat to the
seat plate.
5. Take the remaining bolts and whizlocks
nuts and bolt control levers onto the
outsides of the mount angles, adjusting
them according to operator comfort.
6. Attach the wire harness to the seat switch.
ASSEMBLY INSTRUCTIONS for
42K17Z ; 48K19Z ; 52K21Z.
Remove unit from crate, taking care to
remove inner boxes and the small parts box.
1. Remove deflector chute, bolt bag and
operator’s manual from main assembly.
2. Open bolt bag and lay out bolts:
(4) – 5/16 X 3/4 HHCS
(2) – 5/16 X 1 HHCS
(4) – 5/16 X 1 3/4 HHCS
(2) – 5/16 Nyloc Nuts
(4) – 5/16 Whizlock Nuts
(4) – 5/16 Lock Washers
3. Take the 2 - 5/16 X 1 HHCS and 2 – 5/16
Nyloc nuts and bolt deflector into place.
4. Take the 4 – 5/16 X 3/4 HHCS and
4 – Lock Washers and fasten seat to the
seat plate.
5. Take the remaining bolts and whizlocks
nuts and bolt control levers onto the
outsides of the handle mounts, adjusting
them according to operator comfort.
6. Attach the wire harness to the seat switch.
STARTING ENGINE
Throttle control, ignition switch and choke
control are located between motion control
levers on the front panel under the front of the
seat.
Because of a built-in safety interlock system,
your machine will not start unless the seat is
occupied.
TO START ENGINE: occupy seat, set park
brake, leave the motion control levers swung
out, move throttle control lever halfway to
operating position. Turn ignition key to start
position to engage starter, release the key
when engine starts. Ignition switch is spring
loaded and will return to run position auto-
matically.
Slowly return choke to run position once the
engine has started.
STOPPING ENGINE
TO STOP ENGINE: move throttle lever to
idle position and turn ignition key to “OFF”
position. If engine has been working hard or
is hot, allow engine to idle for a short period
of time before turning off key. This practice
will help cool engine before stopping.
IN CASE OF EMERGENCY engine may be
stopped by turning ignition key to “OFF”
position.
CAUTION:
Always remove the key and set the parking
brake when leaving the machine unattended,
even for just a few minutes.
PREVENT ACCIDENTS:
Do not give
children or unauthorized persons an opportunity
to operate this machine.
SAFETY INTERLOCK SYSTEM
Your Encore Rider is equipped with a Safety
Interlock System that is designed to help
prevent possible serious injuries. Under-
standing and maintaining this system is vital,
for maximum safe operation.
TO START ENGINE:
1. Blades (PTO) must be “OFF”.
2. Control levers in neutral
(swung out).
3. Park Brake “ON”.
4. Operator in seat.
THE ENGINE WILL KILL IF:
1. The operator leaves the seat with:
a. The control levers out of neutral
(swung in).
b. The blades on (PTO).
c. The park brake is “OFF”.
d. All the above.