Serious RED 52K650Z, Руководство оператора

Страница: 7 / 20

ENCORE
6
BELT ADJUSTMENT
Remove key from the ignition switch.
The
deck drive belt, which may be accessed by
removing the deck plate, (see fig.1) has a
turnbuckle assembly to adjust spring tension.
Spring tension should be maintained at 4" of
spring stretch measuring the spring coils. By
turning the turnbuckle clockwise it will in-
crease tension, counter-clockwise will de-
crease tension.
When installing a belt refer to fig. 2 as to the
route of the belt.
CAUTION:
DO NOT over grease housings – it will push
seals out of bearings.
BELT TENSION
TURNBUCKLE
Fig. 1 - Turnbuckle Location
TENSION
IDLER
BLADE
IDLER
ENGINE
PULLEY
F i g . 2 - M o w e r D e c k B e l t L a y o u t
LUBRICATION for 42B350Z ;
42K450Z ; 48B450Z ; 48K550Z ;
52B550Z ; 52K650Z.
The following recommendations on lubrica-
tion should be adhered to. Environmental
conditions may be cause to vary frequency.
Before each use:
„
Clean engine chaff screen
„
Check engine oil and tire
Every 100 hours:
„
Lubricate chassis
„
Lubricate front wheel
„
Lubricate drive and pump control pivot
points
„
Check belt tension
Every 200 hours:
„
Lubricate cutter housings
(1 to 2 pumps)
LUBRICATION for 42K17Z ;
48K19Z ; 52K21Z.
There are 5 grease points on the Z42, 48 and
52. One on each caster, one on the caster
swivel and one on the foot pedal pivot. These
are all pre-greased from the factory. Environ-
mental conditions may be cause to vary
frequency.
Before each use:
„
Clean engine chaff screen
„
Check engine oil and tire pressure
Every 40 hours:
„
Lubricate Casters (3 Pumps)
„
Lubricate Deck Height Foot-Pivot
(1 Pump)
Every 100 hours:
„
Lubricate Caster Swivels (3 Pumps)
„
Lubricate drive and pump control pivot
points
„
Check belt tension