Installing XTN Outlets
5
The first unit must be installed in close proximity to the WAP. Ideally it
should be within 1-2 meters. There should not be any walls, metal
cabinets, mirrors or other wireless (RF) limiting structure between the
first XTN and WAP.
There may be multiple dead or low speed spots in the building. Multiple
remote XTN’s can be used. Ideally an XTN should be located at the
nearest telephone jack to the location were the dead spot is. XTN’s
should be located no closer than 10 meters (30 feet) to each other if
there are no walls or obstacles between units. Always start with XTN
units set to the lowest power setting.
When adjusting the antenna setting adjust 1 unit at a time to obtain
optimal function.
If you must change channels make sure you power down (unplug) the
unit before attempting linkage to the WAP.
Note:
If you are adding an XTN to an existing network you must set the
XTN to the
same channel
as your network.
Your WirePlus XTN
Figure 2
shows the interface, connectors, and LEDs of your XTN.
Figure 2: XTN Interface, Connectors, and LEDs
Antenna
High/Low
switch
