Quick Start
3
2
Quick Start
If you are experienced with hardware and networking, you can use the
Quick Start section to set up your WirePlus solution. If you are not
experienced with hardware and networking, skip the Quick Start and go
to
Chapter 3.
To install your WirePlus outlets:
1. Set the channel selector on the back of the outlet using a
small screwdriver (not provided). The channel is obtained
from the WAP or via client software in the remote
computer.(see
Figure 3
).
2. Slightly loosen the screws on your telephone jack, slide the
plastic base into place, and retighten the screws (see figure
4).
Note:
You do not need to completely remove the screws.
3. Connect the outlet to the telephone jack (see
Figure 5
).
4. Snap the outlet into the plastic base (see
Figure 6
).
5. Switch the antenna on (see
Figure 7
).
6. Attach the power supply (see
Figure 8
).
Note:
If you are installing an XTN, your installation is complete.
