̘
̘
INSTALLATION GUIDE FOR SERAPHIM
DUAL GLASS PHOTOVOLTAIC MODULE
INSTALLATION GUIDE FOR SERAPHIM
DUAL GLASS PHOTOVOLTAIC MODULE
Ta
ble 4
Loads(Pa) Screw Number
Installation Drawing
Installation Site
Outer four holes
Outer four holes
Inner four holes
Inner four holes
4
+ 2400
- 2400
+ 2400
- 2400
+ 5400
- 2400
+ 2400
- 2400
.
4
8
4
+
Nextracker holes
6
&-&$53*$"-*/45"--"5*0/
WARNING Electrical Hazard
This module produces electricity when exposed to light. Follow all appli-
cable electrical safety precautions.
• ONLY qualified personnel can install or perform maintenance work on these PV
modules.
• BE AWARE of dangerous high DC voltage when connecting module.
• DO NOT damage or scratch the rear surface of the module.
• DO NOT handle or install module when they are wet.
The wiring components shall be compatible with the PV modules.
The PV modules connected in serial shall have similar current. The Voc of one PV
string shall no higher than the maximum system voltage, the Voc temperature
coefficient feature and the extreme low temperature of installation location must
be taken into consideration when calculate the Voc of the PV string .
The PV modules connected in parallel shall have similar Voltage. The Isc tempera-
ture coefficient feature and the extreme high temperature of installation location
must be taken into consideration when calculate the Isc of the PV array.
Please refer to local regulations to determine the system wires size, type and tem-
perature.
The cross-sectional area and cable connector capacity must satisfy the maximum
short-circuit of PV system (For a single component, we recommended the
cross-sectional area of cables is 4mm2 and the rated current of connectors is
more than 15A), otherwise cables and connectors will become overheating for
large current. Please pay attention: the temperature limit of cables is 85° C and the
temperature limit of connector is 105°C
A qualified system designer or integrator should always be consulted.
Building permits, inspections and approvals by the local utility are generally
required.
.&$)"/*$"-*/45"--"5*0/
&-&$53*$"-*/45"--"5*0/
12
13