DA
L
19
65
Pag. 3/6
1- Check that the height between the gate and the ground is greater by 65 mm.
2- Choose the position and opening angle of the motor.
3- Get stop blocks and place them right where you want mouvement is to be stopped.
INSTALLING THE MOTORS
PILLAR
INSTALLATION AREA WITHOUT SHEARING HAZARD: up to
90° opening angle
INSTALLATION AREA WITH SHEARING HAZARD up to
:
90° opening angle
MAX 90°
MAX 90°
60mm
6
0
m
m
If the position of the gate towards
the pillar allows it, it is possible to
have also an opening up to 180°,
but in this case it is to consider
that:
- in the points O-A-C there is no
shearing hazard
- in the point B there is shearing
hazard
PILLAR
180mm
6
0
m
m
220mm
1
6
0
m
m
E
G
F
D
In the indicated area Fig. 2 it is possible the correct functioning with shearing hazard up to 90° opening angle
In this case, being the shearing hazard, all needed caution/protection (covers, rubber profiles,
warning signals, etc) must be taken
.
If the position of the gate towards
the pillar allows it, it is possible to
have also an opening over 90°,
but with following limits:
- in the points D-E-F max 100°
with shearing hazard
- in the point G max 150° with
shearing hazard
M
C
/5
C
I
E
O
B
A
C
!
!
Starting from the centre of the hinge, it is possible the correct functioning without shearing hazard -90° opening
angle- in a area measuring 60 x 60 mm, see Fig 1
In this case, being the
shearing hazard, all
needed caution/protection
(covers, rubber profiles,
warning signals, etc) must
be taken
Fig. 1
Fig. 2
WORKING AREA WITHOUT SHEARING
HAZARD UP TO 90° OPENING ANGLE FIG. 3
PILLAR
PILLAR
PILLAR
WORKING AREA WITH
SHEARING HAZARD
PILLAR
PILLAR
PILLAR