DA
L
19
65
Pag. 3/10
6
7
8
9
10 Minitrasmitter
Electric key (selector)
Columns for photocells
Photocells for internal use
Stop block
4 x 0,5 mm
²
3 x 1,5 m
m²
2 x 0,5 mm
²
3
x
0
,5
m
m
²
R
G
5
8
+
2
x
0
,7
5
m
m
²
2 x 0,5 mm
²
2 x 0,5 mm
²
4
5
STANDARD INSTALLATION
1
2
3
4
5
Geared motor + electronic control panel + radio receiver card
Photocells for external use
Limit switch slide blocks
sensitive edge
Flasher with antenna
7
8
400 V~
7
8
4x0,5 mm²
3
6
1
2
9
2
4
2 x 0,5 mm
²
10
irreversible
400/230 V~
±
10% 50/60 Hz
IP54
-20 °C ÷ +60 °C
265 X 250 X 400 mm
with mechanical clutch
+ 150°C
1:30
MT/18
MT/25
2500 Kg
1800 Kg
1,6 A
1050 W
1200 N
1 A
660 W
1200 N
10,5 m/min
10,5 m/min
18,5Kg
19Kg
TECHNICAL DATA OF THE GEAR MOTOR
The motor MT/25 is equipped with inside fan drived
by a thermal device and with cooling lateral grids on
the casing.
The electric fan is activated when the motor
temperature goes over the 50°C.
Advice for wiring up in non-specialised environments.
1. Fit an omnipolar switch upstream of the system, choosing one with a gap of at least 3 mm between the contacts. Or,
alternatively, use a 10A magnetothermic switch.
2. When making the connections (using any type of connector), ensure the system is disconnected from the power
supply, i.e. that the main switch is in the “open” position (“0” symbol). The control unit, in particular, must never be
connected to the power supply either during the wiring up, or when fitting any expansion cards.
3. The following cables must be used for installation of the system:
2
2
- for the control unit and motor power supplies: 1.5 mm section for lengths of up to 19m, 2.5 mm section for
lengths of up to 31 m,
2
2
- for the flashing light: 0.75 mm section for lengths of up to 3 m, 1.5 mm section for lengths of up to 19 m.
- for the low voltage and current lines (e.g. For the photocells, control buttons, electromechanical key, sensitive
2
2
edges and other safety devices): 0.5 mm section for lengths of up to 50 m, 0.75 mm section for lengths of up to
100 m.
4. Wire up the earth connection in compliance with legal provisions.
Motor type
Dimensions
Max gate weight
Power supply
Absorbed current
Absorbed power
Traction and thrust force
Motor power adjustment
Gate speed
Motor thermal protection
Gear ratio
Protection class
Operating temperature
Weight
KI
T/
18
F-
18
H-
25
H
I
E
