SEON Trooper TR4, Инструкция по установке и эксплуатации

Страница: 78 / 90

Troubleshooting
6–2 700-0035 R004
6.1. Troubleshooting the TR4 Plus System
The TR4 Plus System is designed for high reliability of operation. If, however,
you have any problems with your system, read this Troubleshooting chapter. If
you cannot resolve the issue, contact Customer Service at Seon Design.
Symptom Possible Cause and Solution
All system problems. Many system problems are caused by issues with the power supplied to the
DVR. Check the following:
• The voltage to the system may be too low. Check the
LOW VOLTAGE
/
LOW
/
HIGH TEMP
indicator on the back of the DVR. See page 1–6 for
location of the
LOW VOLTAGE
/
LOW
/
HIGH TEMP
indicator.
• The power harness from the DVR must be connected as close to the
battery as possible. Check the wiring to the battery. See page 2–8.
• Check the in-line fuses and fuse holders. If a fuse is blown, determine
the cause before replacing it. See page 2–8.
The DVR does not power on. • Is the internal temperature below 40°F (5°C)? Check the flashing
LOW
VOLTAGE
/
LOW
/
HIGH TEMP
indicator on the back panel of the DVR. The
DVR temperature must be above 40°F to operate. The DVR internal
heater can help to quickly raise the internal temperature of the DVR.
• Is the power and ignition harness plugged into the DVR securely?
The DVR powers on and the green
power indicator is illuminated on the
front panel, but the unit does not start
recording. • Check the ignition wiring from the power input harness. Is the yellow
wire connected to an ignition switched circuit?
• Is the hard drive installed properly with the key in the locked position
on the front panel?
• Is the temperature below 40°F (5°C)? Check the flashing
LOW
VOLTAGE
/
LOW
/
HIGH TEMP
indicator on the back of the DVR. Wait for
the DVR to warm up and start recording.
• Is the temperature above 122°F (50°C)? Check the flashing
LOW
VOLTAGE
/
LOW
/
HIGH TEMP
indicator on the back of the DVR. Check the
fan filter on the back panel for any blockage. If necessary, replace the
fan filter. See page 5–2.
• Check the battery voltage.
• Check the Delay-On Time settings in the Record menu. See page 3–7.
• Are the Timers on? See page 3–10.
• Check the setting for Repeat Record? Go to temporary power and set
the Repeat Record to
ON
.
No Voltage level, Speed or Signals
displayed on playback. • Check Display Voltage is turned
ON
. For more information, see “Using
the Titles/Display Menu” on page 3–6.
• Check the Signals/Speed menu to confirm the selected menu items are
configured properly.
Incorrect speed levels displayed. • Check the calibration settings in the Signals setup menu to make sure
that the speed level is calibrated correctly. See page 3–16.