SEON Trooper TL2, Руководство по установке

Страница: 22 / 84

DVR Setup
2–6 700-0099 R008
7. In the Diagnostic Display menu, select options to display as overlays in the play
view.
8. In the Configuration menu, click Record.
9. In the Record menu, set up record and power delay timers.
The diagnostic display options are a
customer preference. Leave all these
settings On.
Internal Temp Display
: For
temperature measurement display,
leave on default F for Fahrenheit
(USA) or choose C for Celsius
(Canada).
Click
Back
to save the menu
settings.
Figure 2-8 Diagnostic Display Menu
Repeat Record
: Leave at default for
the hard drive to loop and record
over the first recordings when it is
full.
Record Delay On Time
: This sets
the time period from when ignition is
turned on until the DVR starts. Leave
at default to let the bus voltage settle
after the bus starts up to prevent
voltage drops affecting the DVR.
Record Delay Off Time
: Set to 10-
20 minutes to keep the DVR and cameras on after the ignition turns off to record
the bus post-trip check.
Power Delay Off Time
: This delay begins after Record Delay Off time ends.
This sets the time delay from the record delay till power is shut off. During this
time the cameras are turned off and recording is stopped. If Wi-Fi is used, set to
2 hours or more. If no Wi-Fi, leave at default.
Alarm Partition Size
: Leave Off unless instructed otherwise.
Analog Record2
: Leave at 5 FPS unless instructed otherwise.
Click
Back
to save the menu settings.
Figure 2-9 Recording Settings Menu