SentrySafe SFW123ES, Руководство пользователя

Страница: 13 / 48

12
5
Move the safe aside to clear both marked spots for drilling.
6
Drill into the floor:
A For wood: Using the 9⁄32” drill bit, drill a hole 21⁄2”
(64 mm) deep in each marked spot.
B
For masonry: Using the 3⁄8” drill bit, drill a hole 21⁄2”
(64 mm) deep in each marked spot. Install a masonry
anchor in each hole.
7
Replace the safe in the desired position, with the holes in
the safe aligned with those in the floor.
8
Securing the safe:
A For wood: Pass each lag screw through a washer,
then through the safe and into a hole. Tighten with
the wrench.
B For masonry: Pass each lag screw through a washer,
then through the safe and into a masonry anchor.
Tighten with the wrench. Place masonry anchors into
the holes in the floor.
./4% s The safe should not be bolted to a wall, this will compromise the fire rating.
Drill holes through the feet only. Do not drill through the back or sides.
s Bolting/unbolting the unit is at the consumer’s expense and discretion.
s Sentry Group is not responsible for any costs incurred if the unit is to be replaced.
For products that do not come with a bolt down kits.
Go to www.sentrysafe.com to find recommended hardware and instructions.
Bolting Down Your Safe
Bolt down instructions… continued
F