MRP4 / MRP5 / MRP6
P. 5 / 8
EM-4824 Rev.7
WIRING CONNECTION
Refer to the following diagram when wiring. If an optional terminal box is provided, remove its cover and connect lead-
wires.
Figure 7. Wiring Diagram
(1) to (8): Terminal No. of terminal box.
Full-open/-closed signals and forced open/close signals are optional.
Full-closed/overload signals are optional only for model: MRP4.
+
(U)
–
(V)
+
COM1
+
COM2
POWER
INPUT
POSITION OUTPUT (1 – 5V DC)
FULL-OPEN or
FULL-CLOSED
SIGNAL
(
output stem
)
turned CCW
(
output stem
)
turned CW
COM1
FORCED
OPEN/
CLOSE
SIGNAL
(
output stem
)
turn CCW
(
output stem
)
turn CW
1
3
2
4
6
5
7
8
11
9
10
• With Both Full-open/closed Signal
and Forced Open/Close Signal
COM2
COM1
COM2
POWER
black (1)
+
(U)
–
(V)
white (2)
red (3)
+
INPUT
COM1
green (4)
POSITION OUTPUT (1 – 5V DC)
+
yellow (5)
blue (6)
gray (7)
brown (8)
FULL-OPEN or
FULL-CLOSED
SIGNAL
(
output stem
)
turned CCW
(
output stem
)
turned CW
FORCED
OPEN/CLOSE
SIGNAL
(
output stem
)
turned CCW
(
output stem
)
turned CW
OVERLOAD
FULL-CLOSED
FULL-CLOSED or
OVERLOAD SIGNAL
Remark: The yellow wire must be left unconnected if the position output signal is not required. Cut the exposed section of
copper wire and insulate the tip of the wire.
3.2 min.
4.5 max.
3.2 min.
5.9 max.
10
■
WIRING INSTRUCTIONS FOR TERMINAL BOX OPTION
• Other Terminal Box Type
• Sequential Control Signal Suffix Code B
Applicable wire size 1.25 mm
2
Remove insulation by 10 mm.
Rugghölzli 2
CH - 5453 Busslingen
Tel. +41 (0)56 222 38 18
Fax +41 (0)56 222 10 12
www.sentronic.com
Produkte, Support und Service
SENTRONIC
AG
