Sentera Controls DSMFX-2R, Монтаж и эксплуатация

Страница: 8 / 12

www.sentera.eu
MIW-DSMFX-2R-EN-000 - 05 / 07 / 2019 8 - 12
back to the table of contents
Fig. 4 Wiring and connections
Analogue /
modulating
output 1 - T
Analogue /
modulating
output 2 - rH
Analogue / modulating
output 3 - CO
2
Modbus
RTU
A
/B
Supply voltage
DSMFF-2R: 18—34 VDC
DSMFG-2R: 18—34 VDC /
15—24 VAC ±10 %
ATTENTION
Always use two separate transformers: one for the sensor and one for the
controller.
ATTENTION
Do not exceed the maximum power supply rating! Measure before installation!
Unregulated 24 VAC supply units provide higher nominal output voltage and
activate the integrated fuse protection.
ATTENTION
We advise you not to use G and F-type articles together on the same network.
If G and F-type articles are used together on the same network, make sure you
use separate power supplies for the two types. Always connect different article
types to separate AC transformers or use the same article version.
3. Close the enclosure and fix the cover.
4. Switch on the power supply.
5. Customise the factory settings to the desired ones via the 3SModbus software
or Sensistant (if necessary). For the default factory setting see
Table Modbus
register maps .
DSMFX-2R
MULTIFUNCTIONAL
DUCT TRANSMITTER