STC – TC83USB-ASH
STC – TB83USB-ASH
2. 12 Pin Connector
CAUTIONARY NOTE:
a. When the USB signals in the 12 pin connector are in use
1) Please make sure that the cable which connects to the 12 pin connector is an authorized USB2.0
cable. Do not use a cable that is not certified as a standard USB 2.0 cable.
2) Please DO NOT use the USB signal in the 12 pin connector and the USB connector at the same
time. Therefore, DO NOT connect a Mini USB cable to the Mini USB Connector, unless the USB
connection of the 12 pin is disabled (Pin 3 and 4).
CAUTIONARY NOTE:
b. When NOT using the USB signals in the 12pin connector
1) Make sure that the cable which connects to the 12 pin connector does not have a USB signal
connection at pin no. 3 and 4.
With the software, please set up pins for
input (IO0 / IO1) and output (IO2 / IO3).
Depending on the jack type, IO1 and IO2 are
connected to the Input / Output power
connector.
3. Input / Output Connector (2.5 mm Pin Jack)
Please set up for the IO1 and IO2, which signal input and output through this connection with the
software.
4. LED
Red light is on then put the lights out shortly after power on the camera. The LED color changes from
red, to orange, then green. The green light is indicates that the camera is working properly.
No.
Signal
Type
In / Out
1
GND
2
+5V DC
3
USB D-
4
USB D+
5
IO 0 GND
6
IO 0
In
7
IO 3
Out
8
IO 3 GND
9
IO 1 GND
10
IO 1
In
11
IO 2
Out
12
IO 2 GND
IO2 (Out)
GND
IO1 (In)
IO2 (Out)
GND
Stereo Pin Jack
Mono Pin Jack
Product Specifications
6 of 11
Rev 1.1