Sensor Technologies America, Inc.
1345 Valwood Parkway, Suite 320 :: Carrollton, Texas 75006
Phone: (972) 481-9223 :: Fax: (972) 481-9209 :: Toll Free: 1 (877) - SENTECH (736-8324)
www.SentechAmerica.com
16
STC-400 & STC-400L Series
Operating Manual
Rev. 0.1 - Created July 15,2005
9. CCD Spectrum Response Curve
10. Optional Components and Use
IR Cut Filter
When the camera is aimed toward a strong light source such as sun or
fluorescent light, usually vertical smear appears in the screen. This is a
typical phenomenon of interline transfer type CCD. IR cut filter is an
effective device to reduce this smear. IR cut filter built-in models are
also available.
Power Connector
The mating connector for “12-Pin Connector for power and control signal”
(Hirose: HR10A-10P-12S) is available as an optional part. Please wire all
necessary connections according to 6-2.
Pre-Wired Power Connector
The above mating connector with pre-wired cables is also available as an
optional part.This makes connection works to external devices easier.
Tripod Adapter
For easy camera installation, an optional adapter with 14” 20 UNC screw thread
hole is available. With this adapter, the camera can be installed to standard
tripod or other standard camera mounts.
Note:
1. Requires four (4) each M2 screws to mount the TP-300 to the bottom of the
camera. (comes with TP-300 when purchased through SenTech)
2. Maximum length of the four screws must be 7mm
