SENSORPROX 100R/PIN120 -
SINGLE DOOR CONTROLLER
11
10. INITIAL SETUP
The Flash memory of each shipped STAR 100R/PIN120 contains a minimum set of defaulted values, but it
does not have any other preprogrammed values or user’s data in it, therefore, Initial Setup is required upon
the first time the unit is powered-up in order to operate the unit properly.
10-1. Registration of RF Cards for RF CARD ONLY MODE
(1) Apply 12VDC to the unit.
All 3 LEDs will be flashing along with a powered-up melody (do mi sol me do..do mi sol do~).
(2) Press from the keypad. (RF CARD ONLY MODE )
(3) Present RF Cards as follow to register Configuration Card and User Access Cards.
........
Configuration Card User Access Cards Configuration Card again to end task.
NOTE: The user may choose to register the 8 digit card numbers via the keypad instead of
presenting the cards to the unit; this implies that the user must know the 8 digit
representation of each card.
(4) The first card read becomes the Configuration Card and the following RF Cards are registered as
User Access Cards. Once all User Access Cards have been registered, present the Configuration Card
again to complete the registration. (Please keep the Configuration Card in a secure location for future
changes.)
(5) Now, the Main Unit is entered into the normal operation mode with factory defaulted settings.
10-2. Registration of RF Cards with PINs for RF CARD + PIN MODE
(1) Apply 12VDC to the unit.
All 3 LEDs will be flashing along with a powered-up melody (do mi sol me do..do mi sol do~).
(2) Press from the keypad. (RF CARD + PIN MODE )
(3) Present RF Cards as follow to register Configuration Card and User Access Cards + 4~6 digit
Personal Identification Number (PIN) for each User Access Card.
........
Configuration Card User Access Cards + PINs Configuration Card again to end task.
(4) The first card read becomes the Configuration Card and the following RF Cards + PINs are registered
as User Access Cards with assigned PINs. Once all User Access Cards and PINs have been registered,
present the Configuration Card again to complete the registration. (Please keep the Configuration
Card in a secure location for future changes.)
