Sensica sensiLight, Руководство пользователя

Страница: 16 / 24

14
with full contact to the skin. If sensiLight™
is not properly applied or your skin tone
is too dark/tanned, the indicator light will
be “blinking” red. In this case, sensiLight™
will not trigger a pulse in that area of skin.
5. Press the trigger button (see image
- item
2
) and hold it pressed for
continuous pulsing.
6. Press the trigger button once for single
pulse.
7. While pressing the trigger button, you
will see a bright flash, you will hear a
popping noise, and you may feel a mild
stinging and/or heat sensation.
8. Keep the trigger button pressed and start
moving the device with each pulse to
the next spot without detaching it from
the skin. The device will immediately
recharge and will be ready for the next
pulse. Repeat process until the entire
treatment area has been covered.
9. After the treatment, turn off the device
by pressing the “ON/OFF” button; an
orange indicator will light up while the
device is in the shutdown mode. Unplug
the unit after each treatment session.
Important notes:
• Try not to overlap pulses on the same
spot. Repeated pulses on the same spot
may cause burns.
• Do not treat the same area of skin more
than once per treatment as it may cause
skin irritation.
• sensiLight™ will not trigger a pulse if:
• There is no full contact of the
treatment window with the body skin.
• Your skin tone is too dark or tanned.
Recommended treatment
protocol
Typical sensiLight™ treatment
interval
While treating with sensiLight™, do not
overlap pulses on the same spot of skin.
• The first 1-4 hair removal treatments will
be approximately two weeks apart.
• The next 5-7 hair removal treatments will
be four weeks apart.
• Treatment 8+ hair removal treatments
will be as needed, until desire results are
achieved.