Using the RS 5200’s additional functions
34 | RS 5200
* factory default setting
▷
Save the setting by disconnecting the transmitter from the power
supply system (see page 31).
Restoring the factory default settings
To restore the transmitter to the factory settings:
1. Disconnect the transmitter from the power supply system by
unplugging the connector of the power supply unit.
2. Simultaneously press and hold the buttons
L
,
and
R
.
3. Connect the transmitter to the power supply system by connect-
ing the connector of the power supply unit to the yellow socket of
the transmitter while keeping the 3 buttons pressed for at least 3
seconds.
All LEDs on the transmitter flash. The transmitter settings are
restored to the factory settings.
To restore a stethoset receiver to the factory settings:
Status and display of
the protection
function
Function/behavior
activated
2
nd
LED segment lit
The activated hearing profile and the
balance setting cannot be changed/
deactivated.
deactivated*
2
nd
LED segment off
The hearing profiles can be changed at any
time by pressing the Hearing profile button
for 2 seconds. The balance setting can be
changed.
If you are using several stethoset receivers and want to protect
the activated hearing profiles from accidental adjustment, you
can place the stethoset receivers, one after the other, into the
transmitter’s charging compartment to activate the hearing
profile and balance protection.
1
2
3
1A
1A
3s
