Sennheiser PX 360 BT -, Инструкция по эксплуатации

Страница: 13 / 35

Putting the PXC 360 BT into operation
12
Switching the PXC 360 BT on/off
Switching the PXC 360 BT on
왘
Press the Master button
햶
and keep it pressed until the LED
햲
flashes blue. You hear an ascending beep.
– When switching the headphones on for the first time , it will automat-
ically go into pairing mode.
The headphones are waiting to be paired with a
Bluetooth enabled
device (see page 13).
– When the headphones are already paired with an audio source , the
Bluetooth connection is automatically established. You hear an
ascending beep and then you hear your audio source.
– When the headphones are already paired with an audio source but
the audio source is switched off or out of range, the LED
햲
flashes
blue.
The headphones will try for 3 minutes to connect to one of the up to
8 previously paired audio sources. If this fails, the headphones auto-
matically switch off after 60 minutes.
Switching the PXC360 BT off
왘
Press the Master button
햶
and keep it pressed until the LED
햲
flashes 3 times red.
You hear a descending beep. The Bluetooth connection is automatically
deactivated. The headphones switch off.
CAUTION Hearing damage due to high volumes!
Listening at high volume levels for long periods can lead to
permanent hearing defects.
왘
Before putting the headphones on, set the volume to a low
level.
왘
Do not continuously expose yourself to high volumes.
5
1
5
1