Sennheiser G3 100 Series, Инструкция по эксплуатации

Страница: 14 / 24

13
Adjusting settings via the operating menu
Adjusting settings via the operating
menu
The main menu “ Menu ”
Adjusting the input sensitivity – “Sensitivity”
Adjustment range: 0 to –48 dB, adjustable in steps of 6 dB
The transmitter’s audio level display “ AF ” always indicates the audio level,
even if the plug-on transmitter is muted, e.g. allowing you to check the
adjusted sensitivity before live operation.
Selecting the frequency bank and the channel manually –
“Frequency Preset”
When you are in the “ Frequency Preset ” menu item, the RF signal is
deactivated.
Overview of the frequency banks and channels:
Make use of the possibility to adjust settings via the operating
menu of your receiver and to transfer these settings to the plug-
on transmitter.
For more information, refer to the instruction manual of the
receiver. The relevant information is marked with the sync icon.
Input
sensitivity
adjusted ...
Effect/display
... too high Close talking distances, speakers with loud voices or
loud music passages cause overmodulation in the trans-
mission link. The audio level display “
AF ” shows full
deflection for the duration of the overmodulation.
... correctly The audio level display “ AF ” shows full deflection
only during the loudest passages.
... too low The transmission link is undermodulated. This results in
a signal with high background noise.
Adjust a low input sensitivity when using condenser microphones,
adjust a high input sensitivity when using dynamic microphones.
Frequency bank Channels Type
“ 1 ” to “ 20 ” up to 12 per
frequency bank System bank:
frequencies are factory-preset
“ U ” up to 12 User bank:
frequencies are freely selectable
Menu
–12 dB
S e n s i t i v i t y – 12 dB
S e n s i t i v i t y
–36 dB
S e n s i t i v i t y
“Stored”
Call up
“Sensitivity” Select the desired
setting Store the setting
SET
SET
MHz 533.875
B.Ch: 20.12
MUTE
P
AF
Menu
B.Ch: 5.12
Frequency Preset B.Ch:
792.525MHz
Frequency Preset
5 .12 B.Ch:
Frequency Preset
1. 12
Call up “Frequency
Preset” Select the frequency
bank and confirm Select the channel;
store the setting
“Stored”
818.850MHz
SET
SET
SET
SKP100_529675_0409_Sp9.book Seite 13 Donnerstag, 9. April 2009 1:48 13