Putting the devices into operation
11
Mounting the diversity receiver to a camera
Use the supplied CA 2 camera adapter to mount the receiver to a camera’s flash mount.
#
Determine where on the perforated plate
.
the flash mount adapter
/
will need to be
fastened so that the receiver can best be attached to the camera.
#
At this position, place a square nut
0
under the perforated plate
.
.
#
Fasten the flash mount adapter
/
to the perforated plate
.
using the square nut
0
.
#
Lift one side of the belt clip
1
as shown.
#
Press down the belt clip
1
at one fixing point and pull it out of the receiver housing.
#
Repeat for the other side.
#
Place the perforated plate
.
onto the rear of the receiver.
#
Reinsert the belt clip
1
.
#
Use one of the supplied line cables to connect the line input of the camera to the
socket
!
.
.
/
0
The shield of the line cable serves as the antenna for the second diversity section.
1
!
ew 100 P G3 Set _529660_0309_Sp9.book Seite 11 Mittwoch, 8. April 2009 6:57 18
