Senix GTS4QL-M2, Руководство оператора

Страница: 7 / 64

7 WWW.SENIXTOOLS.COM
1. If present, remove the gray spacer from the coupler
opening.
2. Set the unit on a flat, level surface.
3. Turn the knob counterclockwise to loosen the coupler
(Fig. 3).
4. Align the release button with the guide recess
(Fig. 4).
5. Push the attachment straight into the coupler until the
release button snaps firmly into the primary hole
(Fig. 5).
6. Turn the knob clockwise to tighten the coupler.
1. Set the unit on a flat, level surface.
2. Turn the knob counterclockwise to loosen the coupler
(Fig. 3).
3. Press and hold the release button (Fig. 4).
4. Pull the attachment straight out of the coupler
(Fig. 5).
Before operating the unit, make sure the release button
is fully snapped into the primary hole and the knob is
securely tightened.
Unless specified otherwise, the release button should
be snapped into the primary hole only. Using the wrong
hole could lead to personal injury or damage to the unit.
The harness with quick release function can be hooked
behind the rear hand if needed (Fig. 5a).
NOTE: Harness use is optional.
CAUTION:
CAUTION:
Installing the Attachment
Removing the Attachment
INSTALL THE HARNESS
Tighten
Loosen
Knob
Fig. 3
Release Button
Guide Recess
Primary Hole
Fig. 4
Coupler Attachment
Fig. 5
Fig. 5a