Senix GTS4QL-M2, Руководство оператора

Страница: 10 / 64

10 WWW.SENIXTOOLS.COM
STOPPING INSTRUCTIONS
engine to warm up for 30 to 60 seconds at idle speed
before increasing cutting speed.
7. To increase trimmer cutting speed, press and hold
the throttle lockout with one hand, and then squeeze
the throttle control with the other. The further you
squeeze the throttle control, the more the cutting
speed will increase (Fig. 7).
NOTE:
The lockout will remain engaged as long as the
throttle control is being squeezed.
NOTE:
To prevent the throttle control from being
squeezed accidentally, this unit has a throttle lockout.
The throttle control cannot be squeezed unless the
throttle lockout is also engaged.
IF...
the engine does not start, begin the starting
procedure with step 3.
IF...
the engine fails to start after 3 attempts: Press and
hold the throttle lockout. Squeeze and hold the throttle
control. Pull the starter rope with a controlled and
steady motion until the unit starts.
IF...
the engine stops while the throttle control is
squeezed, begin the starting procedure with step 3.
IF THE ENGINE IS HOT...
begin the starting procedure
with step 4.
1. Release the throttle control and allow the engine to
idle.
2. Press and hold the On/Off switch in the Off (O)
position until the engine comes to a complete stop
(Fig. 7). Make sure the cutting attachment has
stopped before the unit is set down.
Throttle Control
On/Off Switch
(I = On / STOP = Off)
Throttle
Lockout
Fig. 7
Primer Bulb
Fig. 8
Choke
Fig. 9
Starting
Position
Throttle Control
Starter Rope Grip
Fig. 10