15
WWW.SENIXTOOLS.COM
MAINTENANCE
CLEANING AND STORAGE
CLEANING
WARNING:
To avoid serious personal
injury, always stop the engine and allow it to cool before
cleaning or maintaining the unit.
Use a small brush to clean the outside of the unit. Do not
use strong detergents. Household cleaners that contain
aromatic oils such as pine and lemon, and solvents such
as kerosene, can damage plastic. Wipe off any moisture
with a soft cloth.
STORAGE
• Never store a fueled unit where fumes may reach an
open flame or spark.
• Allow the engine to cool before storing.
• Lock up the unit to prevent unauthorized use or
damage.
• Store the unit in a dry, well-ventilated area.
• Store the unit out of the reach of children.
Long-term Storage
1.
Remove the fuel cap, tip the unit and drain the fuel into
an approved container. Reinstall the fuel cap.
2.
Start the engine and allow it to run until it stalls.
This ensures that all fuel has been drained from the
carburetor.
3.
Allow the engine to cool. Remove the spark plug and put
5 drops of any high-quality motor oil into the cylinder.
Pull the starter rope slowly to distribute the oil. Reinstall
the spark plug.
4.
Thoroughly clean the unit and inspect it for any loose or
damaged parts. Repair or replace damaged parts and
tighten loose screws, nuts or bolts.
Preparing the Unit for Use after Long-term Storage
1.
Remove the spark plug. Tip the unit and drain all of the
oil from the cylinder into an approved container. Reinstall
the spark plug.
2.
Change the oil. Refer to Changing the Oil.
Note:
Do not use fuel that has been stored for more than
30 days. Dispose of old fuel and oil according to
federal, state and local regulations.
FUEL SYSTEM
Empty the fuel system before storage for 30 days or longer.
Drain the gas tank, start the engine and let it run until the
fuel lines and carburetor are empty. Use fresh fuel next
season. Under OIL AND FUEL section of this manual,
see message labeled IMPORTANT regarding the use of
blended and E85 fuel in your engine.
Fuel stabilizer is an acceptable alternative in minimizing
the formation of fuel gum deposits during storage. Add
stabilizer to gasoline in fuel tank or fuel storage container.
Follow the mix instructions found on stabilizer container.
Run engine at least 3 minutes after adding stabilizer.
ENGINE
• Remove spark plug and pour 1 teaspoon of engine oil
through the spark plug opening.
Slowly pull the starter rope 8 to 10 times to distribute oil.
• Replace spark plug with new one of recommended type
and heat range.
• Clean air filter.
• Check entire unit for loose screws, nuts, and bolts.
Replace any damaged, broken, or worn parts.
• At the beginning of the next season, use only fresh fuel.
OTHER
• Do not store gasoline from one season to another.
• Replace your gasoline can if it starts to rust.
Содержание BL4QL-L
Страница 17: ...17 WWW SENIXTOOLS COM PARTS PARTS EXPLODED VIEW ...
Страница 20: ...20 WWW SENIXTOOLS COM GENERAL INFO ...