Operation Manual
MMS-1A-RS / MMS-1X-RS
Revision 4.0, September, 2020
Doc Nr: MP.MMS-1A-RS.OM.400.02_E
Page 35/74
7.
Operation instructions
Dashboard tab
Figure 62:Dashboard Screen appears on the software start
Top level controls (always visible)
Figure 63: Basic controls
Coordinate systems:
•
The Coordinate system selector allows to select preconfigured or custom coordinate systems.
•
User coordinates show the current position with reference to the selected coordinate system.
•
Mechanical coordinates show the position with reference to the index pins of the encoders.
Probe and Measurements:
•
Measurement range selector allows selection the active measurement range.
•
The refresh button next to the Measurement range selector allows manually starting the probe
selection. This button starts the RFID probe detection process. The probe detection process can be
aborted to allow selecting a probe manually.
•
The Selected probe field shows the currently active probe.
•
Low cut-off filter allows switching on and off a digital 2
nd
order Bessel low pass filter and selecting the
cut off frequency.
•
If the Warning checkbox is activated the system will calculate the cut off frequency based on the
selected spatial resolution and the scanning speed and will display a warning with the option to set
the suggested cut off frequency.
•
The selector below allows selecting a no phase filter instead of a standard filter.
