MI002273-E
ENGLISH 2/8
1.0 DISCLAIMER
Before executing any operation it’s mandatory to read all the content of this
user manual. Only electrical-skilled technicians can use the module
described in this user Manual; it is responsibility of the installer to verify that
the installation complies with safety standards.
Only the Manufacturer is authorized to repair the module or to replace
damaged components.
No warranty is guaranteed in connection with faults resulting from improper
use, from modifications or repairs carried out by Manufacturer-unauthorised
personnel on the module, or if the content of this user Manual is not followed.
2.0 DESCRIPTION AND GENERAL FEATURES
2.1 Description
Single-phase switching power supply for Seneca modules: it can be installed on DIN
46277 rail. Input voltage range: 100-260 Vac @ 47 - 63 Hz; output: 24 Vdc @ 1,5 A.
2.2 General features
AC input rated voltage from 110 Vac to 230 Vac @ 47 Hz-63 Hz, 0.7 A
DC input rated voltage from 110 Vdc to 315 Vdc @ 0.7 A
Output voltage: 24 Vdc ± 2% (it is possible the redundancy between two Z-SUPPLY
through connection in parallel of their respective output, ONLY by IDC10 connector)
Output maximum-current: 1.5 A
Internal fuse: 1.25 A, type T (delayed), for the protection against of the over-current and
over-voltage
Quick installation on DIN 46277 rail
Isolation up to 3 KVac between input voltage and output voltage
LED to signal the status of the output voltage and power supply
It is possible to supply the modules of the Seneca Z-PC Line through IDC10 connector
3.0 TECHNICAL SPECIFICATIONS
3.1 General specifications
Efficiency
87% @ 1.5 A, 230 V, cosΦ 0,7
Power supplied
36 W max
Isolation between: input, output
3 KVac / 60 s
Over-voltage category/Pollution
degree
II/2
Power consumption (no load)
< 1.4 W
Power consumption (full load)
< 6.6 W
Current trip protection
1.7 A
This module is designed for connection to hazardous electric voltages.
Ignoring this warning can result in severe personal injury or mechanical
damage.
