10
2.4 Wireless Access Router with static IP
Ethernet connection
1. Set the OWAP as a Router (
Wireless Interface IP is 192.168.1.1,
Ethernet Interface IP is 192.1682.1, must turn on NAT on Ethernet
Interface, default route is 192.168.2.254
).
2. Set Wireless parameters on OWAP: Channel (
1
) and SSID
(
wireless
)
3. Turn on DHCP server on the OWAP and assign IP address to PC1,
PC2 and PC3.
4. Set Wireless parameters on client stations PC1, PC2 and PC3:
SSID (
wireless
).
11
Chapter 3. Web Access
Web Connection
The SendFar Wireless Access Point (OWAP) supports access to the
configuration system through the use of an HTTP Interface (web browser).
Before configuring the OWAP, you need to know the IP Address assigned
to the unit.
When shipped from the factory, the IP Address (192.168.2.1) was assigned
to the OWAP by default.
To start a web connection use:
http://192.168.2.1/
Identify the IP Address assigned to the unit
However, the IP Address may be changed and you cannot connect the unit
using the default IP Address. In this case, you must identify the OWAP IP
Address before configuration. To identify the IP Address, you can use the
Serial Port to gain access the current network status. To start a Serial Port
connection:
1.
Attach a serial data (RS-232) cable to the Serial Port Adapter.
Connect the other cable end to a terminal or a PC running a terminal
emulation program. Use a 9-pin female to 9-pin female NULL Modem
cable.
2.
Set the terminal to
115200
Baud,
No
-Parity,
8
data bits,
1
Stop bit,
and ANSI compatible.
Note: Running a terminal emulation program on your PC, such as
HyperTerminal, and then set the following connection properties:
z
Click
the
Start icon
>
Program
>
Accessories
>
Communication
>
Terminal
.
z
Create a new connection file, and then select a Com Port
<
COM1, COM2, etc., depending on your PC>
with
115200
bps /
8-bits / 1-stop
.
z
Click the properties icon in the
Tool Bar > setting > select
Emulation terminal
VT100
>
ok
.
