TERRAIN ADJUSTMENT
Each 350 / 500 Leg has 15 mm of Terrain Adjustment to help level the Tabletop on uneven ground
STORING YOUR 350 and 500 LEG SETS
You will find STRAP Slots on the sides of your 600 and 1200 Tabletop Sides (Strap provided with each Leg Set).
Remove / Unbolt your 350 / 500 Vertical leg components and place them to one side. Fold the Curved Leg Components inwards
until they are horizontal. Feed the strap through the slots on either side and thread back through the buckle. Keep the tape flat
for an even pull. You might want to cut the tape of the strap shorter. You should carefully seal the ends with a hot knife to
prevent fraying of the material. Place the M10 x 40 Button head bolts and washer back into the Table to store and prevent loss.
350 Leg Set Installed and in Storage – 500 Leg Set Installed and in Storage
JOINING YOUR TABLETOP TO A RAMP 200 / 350 / 500 Heights
RAMP TO RAMP – SINGLE TABLETOP NOE LEGS:
Create a Take OFF to landing Ramp with ONE 600 or 1200 Table. Simply remove and store all leg sets with a strap if they are
installed on your Tabletop. Then Hook the Tabletop onto the bolts on the Take off and landing Ramp and tighten to 12 Nm.
ONE RAMP TO ONE TABLETOP DROP OFF OR CASEPAD:
Unfold / Choose the Leg Set on the Tabletop to match the ramp you are using. Secure the bolts at 12 Nm for maximum strength.
Place 2 x M10 x 40 mm Button head bolts with 2 x large Washers into the BACK PLATE of your Ramp. Hook the Tabletop over the
Bolts in the Back plate whilst keeping the washers to the inside. We recommend having a SMALL 6 mm HEX KEY OR BETTER /
FASTER a TORQUE / Ratchet Wrench (with Quick Release) with 6 mm attachment. Easier to reach into the space behind a leg set.
You may need to loosen the straps and drop the legs a little to access the bolts on the lower ramps. You can also lift / tilt the
ramp to one side being very careful not to add excessive leverage to either part. Strap legs back into storage before use.