8:
Take Deck Support marked 1 – 2 and 3. Take 3 x LB (Left Side Batons). Turn the numbers so you can read them in ascending
order. The LB Batons go in the rails under the LEFT side of Deck Supports 1 / 2 / 3. When you turn Part 1 / 2 / 3 over this is the
end / side with full depth HOLES - NOT the full depth slots!
LB Batons should be flush with the end of parts Deck Supports 1 / 2 / 3 and in the rails. Turn these parts over and drill through
the marker points in 1 / 2 / 3 into LB below. The hole depth should be the same length as the screw 50 mm and using a 4mm
Drill bit. This will prevent splitting the batons.
Repeat the same on all Deck Supports 1 / 2 / 3. Make sure the head of the screw is flush with the surface.
9:
Take 6 x T nuts and place these into the bottom face of parts 1 / 2 / 3 beside LB Batons. Fix these with 12 x small screws
Take the LEFT Side Panel and slide this onto Deck Supports 1 / 2 / 3. Deck Support 1 is at the BACK of the trainer. Deck Support 3
is at the FRONT! The number should be readable from the back!