Image ABOVE shows 4 x 80 mm Button Head Bolts and 4 x 100 mm Button Head Bolts supplied with your trainer.
Move to the FRONT of the Trainer. Set the Right Side panel at the 80 mm wide position using the marks on the Deck Supports
(The RIGHT Side Panel is now on the LEFT!). Take a 100 mm Button Head Bolt and place this through the hole at the FRONT of
the Trainer as shown. Place a Washer over the bolt end – then wind on 2 No Nuts and then add a second Washer. Push the bolt
through until it connects with the LEFT (right) Side panel and wind into the T nut a few threads.
14:
Choose the wheel size you will be using. These bolt locations will never be exact because there are so many different types
of tyre tread and tyre wear! But they are close enough for the purposes of the trainer. Reminder: We are 29er for this example!
20
24 / 26
27 / 29
16 Inch Adapter Instructions with the NEW ADAPTER.
Place 1 No 100 mm Button Head Bolt through the LOWER holes in the RIGHT Side panel at 27 / 29. Then place 1 No 100 mm
Button Head Bolt through the UPPER 27 / 29 Hole. IF you have problems locating the bolt on the thread NEVER force the bolt or
you WILL cross thread. IF the bolt will not catch the thread of the T Nut remove the bolt from the RIGHT side and try and place it
directly into the T nut to check it works. Sometimes it can take a little time and patience. Once it is working replace it through
the RIGHT side and catch the thread. A little silicone spray can help if the trainer is well used and the bolt has grit on the thread!
Maintenance
. Make sure the T Nut is LOOSE. This is an assembly stage. A loose T Nut is easier to locate!