SCP 2100
– User Manual
Page 5 (62)
SAFETY PRECAUTIONS
There is always a danger present when using electronic equipment.
Unexpected high voltages can be present at unusual locations in defective
equipment and signal distribution systems. Become familiar with the equipment
that you are working with and observe the following safety precautions.
Every precaution has been taken in the design of your SCP 2100 to ensure that it
is as safe as possible. However, safe operation depends on you the operator.
Always be sure your equipment is in good working order. Ensure that all points
of connection are secure to the chassis and that protective covers are in place
and secured with fasteners.
Never work alone when working in hazardous conditions. Always have another
person close by in case of an accident.
Always refer to the manual for safe operation. If you have a question about the
application or operation call Sencore for assistance.
WARNING
– To reduce the risk of fire or electrical shock never allow your
equipment to be exposed to water, rain or high moisture environments. If exposed
to a liquid, remove power safely (at the breaker) and send your equipment to be
serviced by a qualified technician.
To reduce the risk of shock the SCP 2100 must be connected to a mains socket
outlet with a protective earthing connection.
For the SCP 2100 the mains plug is the main disconnect and should remain readily
accessible and operable at all times.
The SCP 2100 is equipped with an internal system battery. The SCP 2100 must
be sent to Sencore service for replacement
of this battery.
To reduce the risk of shock and damage to equipment, it is recommended that the
chassis grounding screw located on the rear of the SCP 2100
– be connected to
the installation’s rack, the vehicle’s chassis, the battery’s negative terminal, and/or
earth ground.
CAUTION
– Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type.