EN 7
EN
Revision 11/2019
Copyright © 2019, Fast ČR, a. s.
Device and controls
•
Date & time
You can set the time and date manually in the menu.
Working with USB
In addition to power, the connector (
9
) is used to transfer data from the memory
card in the camera to the computer. However, not from the computer to the
card (erasing, formatting), perform the file management either with the camera
functions or by moving the card into the card reader on the computer. The
connected card is reported as another disk drive. The Mass Storage message lights
up on the camera display.
2.5. Start-up, warm-up
1.
Charge the device away from the car, press and hold the On / Off button
(5s) for a long time and set it to suit your needs as described in this manual.
At the end of the initial procedure, switch the device off by holding down
the On/Off button (up to 3 s).
2.
Install the camera and mount to a suitable place on the wind shield and
manually activate the camera connection to power supply for automatic
activation.
3.
If you manually turn on the camera, turn it off manually when finished
recording (not necessary if you have automatic shutdown).
2.6. Operating modes and use
MODE button for mode select
1.
Turn on the device by pressing On / Off, after the welcome screen an
operational screen appears with status icons and indicators. If the power
supply is connected (e.g. in the car), the camera will immediately begin to
record, in which case you can press REC/OK to stop the recording process.
2.
Press the MODE button to switch between the Camera recording mode
(Camera)
, taking photos (Photo)
and Playback of previous
recordings. Action icons are displayed in the top left corner of the screen.
Содержание SCR 4500
Страница 2: ......
