Sencon SI9000 plus, Руководство пользователя

Страница: 8 / 45

8 ENAMEL RATER MANUAL: V.10
2. GETTING STARTED WITH YOUR
2.1 SAFETY
The test voltages used by the are sufficiently low so as to
present no hazard whatsoever under all circumstances. Although
potentially dangerous mains voltages are present inside the unit,
the construction of the case to I.P.65 rating will prevent any hazard
from this whilst the case remains intact. Should the facia become
perforated or the case become damaged in such a way as to
destroy the seal then the unit must be removed from service
immediately and returned to Sencon for repair. Operators should
be warned to keep electrolytes away from electrical socket outlets
and never handle plugs with wet hands.
2.2 SETTING THE MAINS VOLTAGE
The mains voltage of the is factory set as appropriate for
the particular country to which it is supplied and the setting will be
clearly marked on the back panel. Should you need to change the
voltage proceed as follows:-
i. Remove the six button head screws in the base of the
case using the 2.5mm hex wrench supplied.
ii. Remove the base panel taking care not to damage the
earthing cable.
iii. Referring to Appendix A Fig 1 move the mains voltage
switch to the required position.
iv. Check that the foam seal on the bottom of the case is
intact and replace the base panel and six screws.
v. Change or remove the voltage label.