Tool Operation
12
l
(1) Pull the trigger to start
the motor. (2) Press the
nosepiece, with constant
force, against the work
surface. Do not remove the
tool from the work surface until
the clutch disengages and the
bit stops rotating, signaling a
fully driven screw.
l
(3) Continue to allow the
motor to run. The next screw
will be automatically fed
into place when the tool is
depressed against the work
surface.
l
Feed the strip into the slide
body until the 2nd empty slot
is aligned with the bit. The
tool will feed the fist screw
when depressed against the
work surface.
l
To remove the strip pull it
through from the top of the
nosepiece.
l
Whenever possible, hold the
tool at a right angle to the
work surface.
Trigger lock
l
To lock the trigger for
continuous operation, depress
the trigger and push in the
locking button then release the
trigger. The tool will continue
to run. To turn off, squeeze
and release the trigger.
l
Release the thumbwheel
by depressing the red lock
button. Adjust the countersink
by turning the depth
adjustment thumbwheel. Refer
to the markings on the tool for
proper direction. Release the
lock button after adjustment.
Depth of Drive
Adjustment
l
This tool is equipped with a
locking depth control
adjustment
