35
ProBee-ZE10 User Guide Rev.1.1
5
Digital and Analog I/O
5.1
GPIO Configuration
The ZE10 module has total 14 I/O pins. Among these pins, I/O pin 6 is assigned to factory reset only and
the user can use the rest 13 pins for general purpose inputs and outputs. The I/O pin assignments are
shown in Table 5-1. As shown in Table 5-1, some pins provide special functions built into the firmware.
Table 5-2 describes the special functions tied to the specific pins.
Table 5-1 Default I/O Pin Assignments (ZE10)
Pin Number
GPIO Number
Special Functions
AI Enable
6
-
Factory reset / Bootloader (
SW_0
)
X
5
0
Permit joining / Wake-up (
SW _1
)
X
3
1
Power LED (
LED_0
)
X
4
2
Status LED (
LED_1
)
X
7
3
O (AI_0)
8
4
O (AI_1)
10
5
O (AI_2)
11
6
O (AI_3)
24
7
X
22
8
UART_CTS
X
23
9
UART_RTS
X
19
10
UART_DTR
X
18
11
UART_DSR
X
17
12
X
The AT command below can be used to change the GPIO settings.
AT+GPIO=<values><CR>
or
AT+GPIO<number>=<value><CR>
Where, <values> is a number between 0~5 as explained below:
0
Disabled (unmonitored digital input)
1
Digital input, monitored
2
Digital output, default low
3
Digital output, default high
4
Analog input, single ended (only valid for GPIO3~6)
5
Reserved for pin-specific alternate functionalities (See Table 5-2)
