14
blinks 3 times every 2 seconds. Now press again the Pairing Button for 2 seconds until Connect
LED blinks every 0.5 second.
Step 5.
Wait for SD1 & SD2 to be connected for a while until Connect LED’s of SD1 and SD2 is lit in
green. It takes about 10 seconds to make a connection. If there are many Bluetooth devices nearby,
it will take a little bit more.
Step 6.
Turn SD1 off and on. Connect LED blinks twice in green every 3 seconds.
Step 7.
Turn SD2 off and on. Connect LED blinks once in green every 1 second.
Step 8.
Now a pair of Parani-SD is configured to make automatic connection, whenever power off and
on.
Just use this pair of Parani-SD like virtual serial cable.
* Note: While pairing is progressing by the pairing buttons, the Command Response will be inactivated
automatically. Then, Parani-SD will not send the response messages such as OK, Connect and
Disconnect.
Table 3-6 Pairing Process by Pairing Button
SD1 Status
LED
SD2 Status
LED
1. Hard reset
Mode0
Standby LED turns on
1. Hard reset
Mode0
Standby LED turns on
2. Push pairing
button
Mode3
Connect LED blinks 3
times every 2 seconds
2. Push pairing
button
Mode3
Connect LED blinks 2
times every 2 seconds
3. Push pairing
button again
Mode1
Connect LED blinks
every 0.5 seconds
4. Connected
Slave
Connect LED is lit in
green
4. Connected
Master
Connect LED is lit in
green
3.3.6. Software and Utility
This configuration software and utility for firmware update comes with the product, which also can be
downloaded from http://www.sena.com
Table 3-7 Configuration Software
Software Purpose
Operating
System
ParaniWIN
Configuration
MS Windows 98SE or Higher
ParaniUpdater
Firmware Update
MS Windows 98SE or Higher
3.3.7. ParaniWIN
ParaniWIN is a program running on Microsoft Windows for the configuration of Parani-SD. Install
ParaniWIN on your computer. Plug a Parani-SD into the serial port of the computer and turn on the
power. Run ParaniWIN.
