Sena Parani-SD 100, Руководство пользователя

Страница: 26 / 27

Parani-SD100 User Manual – Appendix A. AT Commands
A-6
CONNECT 112233445566
or
OK
ERROR
Purpose Connect to the Bluetooth device with given BD address
Parameters 112233445566=BD address
Description Parani-SD100 attempts to connect to the Bluetooth device with the given BD address.
To make successful connection, the Bluetooth device must be in Page scan. This
attempt continues for 5 minutes.
If it fails to make connection, SD response is
‘
ERROR
’
.
Example ATD000B530011FF
15 ATH
SD Response OK
DISCONNECT
Purpose Release the current connection
Description The current Bluetooth connection is released normally. It takes about 30 seconds to
detect an abnormal disconnection such as power off and moving out of service range.
16 AT+BTLPM,n
SD Response
OK
Purpose Set low power mode
Parameters n=0: Inactivate (Default)
n=1: Activate
Description During no data transmission, Promi-SD can be in low power mode to save the power
consumption. It takes a few seconds to wake up Promi-SD in low power mode.
17 AT&V
SD Response S0:m0;S1:m1;
…
Sn:mn
OK
Purpose Display all the S-register
Description All parameters are stored at S-register in flash memory. These values are sustained until
hardware reset.
18 ATSnn?
SD Response value
OK
Purpose Display a given S-register
Parameters nn= Address of S-register
Description A specific S-register is displayed.
19 ATSnn=mm