Parani-SD100 User Manual – 2. Configurations
11
4.
Press the Pairing Button of SD2 for 2 seconds until Standby LED turns off and Connect LED blinks 3 times every
2 seconds. Now press again the Pairing Button for 2 seconds until Connect LED blinks every 0.5 second.
5.
Wait for SD1 & SD2 to be connected for a while until Connect LED’s of SD1 and SD2 is lit in green. It takes
about 10 seconds to make a connection. If there are many Bluetooth devices nearby, it will take a little bit
more.
6.
Turn SD1 off and on. Connect LED blinks twice in green every 3 seconds.
7.
Turn SD2 off and on. Connect LED blinks once in green every 1 second.
8.
Now a pair of Parani-SD100 is configured to make automatic connection, whenever power off and on.
9.
Just use this pair of Parani-SD100 like virtual serial cable.
SD 1
status
LED
SD 2
status
LED
1. hard reset
Mode0
Standby LED turn on.
1. hard reset
Mode0
Standby LED turn on.
2. push pairing
button
Mode3
Connect LED blinks 3
times every 2 sec.
2. push pairing
button
Mode3
Connect LED blinks 3
times every 2 sec.
3.
3. push pairing
button agian
Mode1
Connect LED blinks every
0.5 sec.
4. connected
Slave
Connect LED is lit in
green
4. connected
Master
Connect LED is lit in
green
Содержание Parani-SD 100
Страница 14: ...Parani SD100 User Manual 3 Connections 12 3 Connections z RS232 Interface z Pin Assignment z Power Supply...
Страница 16: ...Parani SD100 User Manual 3 Connections 14 Pin Assignment To Host with DTE Interface To Host with DCE Interface...
Страница 21: ...Parani SD100 User Manual Appendix A AT Commands A 1 Appendix A AT Commands z Terminology z Command Description...